#12kb on nucleo f401re how to
#12kb on nucleo f401re install
#12kb on nucleo f401re drivers

Here is how to operate an LED using Bluetooth from a mobile and PC terminal.Ĭonnect HC-06 module to Arduino headers on Nucleo ST F401RE as shown in fig below D10 and D2 pins are configured by default. Instead of using this procedure I feel comfortable in using the default receiver and transmitter pins of Nucleo board. In order to enable them, some of the solder bridge configurations (open/close of some pins) are required. Remember, TX/Do and RX/D1 pins of Nucleo Arduino connectors are not enabled by default. Connect bluetooth module to nucleo board as follows:

These are the steps to be followed to establish communication between them:īluetooth HC-06 has 4 pins namely RXD, TXD, GND and VCC. Hence I explored on how to communicate Arduino Bluetooth HC-06 Slave module with Nucleo ST F401RE. There are no libraries for Bluetooth HC-06 module. In mbed repository there was variety of libraries and programs that illustrates Bluetooth communication using different modules. Nucleo board has arduino supported header pins thereby allowing the board to use with other Arduino supported devices/modules.

This ensures firmware was upgraded successfully.

#12kb on nucleo f401re drivers

Device details will be prompted if the ST-Link drivers were properly installed and then press yes.Run the STLinkUpgrade.exe program and press connect.Download latest firmware version from here.Download latest version firmware from here.Follow the prompts and finish the installation.Extract the Zip folder and run either dpinst_amd64.exe or dpinst_x86.exe depending on PC configuration.

#12kb on nucleo f401re install

Download and install the ST-Link drivers.

For smoother functioning of the board ensure that the board will have latest version of firmware installed on it. This blog will walk you through the process to enable the communication between Bluetooth module HC-06 and Nucleo ST F401RE, an mbed enabled Nucleo board.Īs Nucleo boards are having some issue with the firmwares installed it is mandatory to have the latest firmware installed on the board. ST Nucleo F103RB, ST Nucleo L053R8, ST Nucleo F401RE and ST Nucleo F302R8 are some of the boards from STMicroelectronics.īy default the bluetooth communication is not enabled on the Nucleo ST F401RE board. This will also bestows a wide variety of shields that supports functions such as Bluetooth Low Energy (BLE), Wi-Fi connectivity, GPS, proximity sensing etc. These Nucleo boards will allow developers to re-use hardware and software IP for multiple projects thereby making them more scalable. STMicroelectronics (STMicro) has announced an mbed enabled development board named STM32 Nucleo. Some of the most popular boards are mbed LPC1768 from NXP, mbed LPC 11U24, Seeeduino-Arch etc. There are numerous boards available in market with different configurations from different vendors. ARM mbed is designed to provide highly productive Internet of Things solutions.